Troubleshooting Guide: Jet Pump Not Pumping Water

Jet pumps are an essential tool for pumping water in rural areas or where there is no access to a municipal water supply. Jet pumps operate by creating a vacuum that draws water from the well into the pump, where it is then pressurized and sent through pipes to the home or other structures. Why is Jet Pump Not Pumping Water?

However, sometimes the jet pump may fail to pump water, which can be a frustrating problem for homeowners. In this blog post, we will explore the possible reasons why a jet pump may not be pumping water and the steps you can take to troubleshoot the issue.

Possible Causes of Jet Pump Not Pumping Water

There are several possible causes for a jet pump failing to pump water. Some of the common causes include:

1. Low Water Level

If the water level in the well is too low, the jet pump may not be able to draw water into the pump. In this case, you may need to lower the pump further into the well or wait for the water level to rise.

2. Clogged Intake

A clogged intake or suction line can also cause the jet pump to fail to pump water. Debris, such as dirt or leaves, can accumulate in the intake, preventing water from entering the pump.

3. Damaged Impeller

The impeller is the rotating part of the pump that creates suction to draw water into the pump. If the impeller is damaged or worn, it may not be able to create enough suction to pump water.

4. Air Leaks

Air leaks in the suction line or pump housing can also cause the jet pump to fail to pump water. Air leaks can disrupt the vacuum and prevent water from entering the pump.

5. Electrical Issues

If the pump motor is not receiving enough power, it may not be able to operate properly, resulting in a failure to pump water.

Troubleshooting Steps:

To troubleshoot a jet pump that is not pumping water, follow these steps:

1. Check the Water Level

Make sure the water level in the well is sufficient for the jet pump to draw water. If the water level is too low, lower the pump further into the well or wait for the water level to rise.

2. Check the Intake

Inspect the intake or suction line for clogs or debris. Remove any debris that may be blocking the intake.

3. Inspect the Impeller

Check the impeller for signs of damage or wear. If the impeller is damaged, replace it.

4. Check for Air Leaks

Inspect the suction line and pump housing for air leaks. Seal any air leaks that are found.

5. Check Electrical Connections

Ensure that the pump motor is receiving sufficient power. Check the electrical connections and replace any faulty components.

Possible causes of Water Pump Not Turning ON

There are several possible causes for a water pump failing to turn on. Some of the commaon causes include:

1. Power Supply Issues

If the water pump is not receiving enough power, it may not be able to turn on. This could be due to a blown fuse, tripped breaker, or faulty electrical connections.

2. Faulty Pressure Switch

The pressure switch is responsible for turning the water pump on and off. If the switch is faulty or malfunctioning, the pump may not turn on.

3. Clogged Intake or Discharge

A clogged intake or discharge line can prevent water from flowing into or out of the pump, causing it to fail to turn on.

4. Malfunctioning Pump Motor

If the pump motor is faulty or malfunctioning, it may not be able to turn on and pump water.

To fix there problems click here to read the complete article Troubleshooting Steps of Water Pump Not Turning ON

Conclusion:

A jet pump that fails to pump water can be a frustrating problem for homeowners. By following the troubleshooting steps outlined in this blog post, you can identify the possible causes of the problem and take the necessary steps to fix it.

If you are unable to identify the cause of the problem or are unsure of how to fix it, it may be best to seek the assistance of a professional plumber or well technician.